Epilog Fusion13000 Owner's Manual page 66

Section 5: Installing the Epilog Dashboard
5. The window below will appear. Select Use the following IP address radio
button.
6. Type in the following (leave everything else blank on this page).
IP Address
Subnet Mask
Default Gateway
7. Click the OK button in this window and then click on the Close button in
the next window.
8. Your computer is now set to print through a crossover cable to the Ethernet
port on the laser.
Print Driver
192 168 3 3
255 255 255 0
Leave blank
36
This number is not an error --
the last digit of the IP address
in this window must be
different than the IP address
set in the Fusion.