Epilog Fusion13000 Owner's Manual page 40

Laser Cooling
Operating Temperatures
All Epilog laser systems use air-cooled laser tubes. Laser technology is such that
the laser tubes generate a lot of excess heat and the tubes must be cooled for
proper operation. There are cooling fans located at the back of the laser. The fans
and vents should always be clear of restrictions and should never be covered.
Warning: The cooling fans and vents are located at the back of the Fusion and
should never be covered or blocked in any way. Lasers that overheat will not
operate properly and may begin to produce erratic laser output or possibly
complete failure.
Ambient air temperature where the laser system is operating should not exceed 90 degrees F (32
C). Operating in an environment where the ambient air temperature is above 90 degrees F (32 C)
will void the Epilog warranty.
Section 3: Getting Started
10
Requirements and