Epilog Fusion13000 Owner's Manual page 133

Section 9: Using the ECC (Epilog Control Center)
Clicking on the Play button will start the job you have selected. If you have placed your material in
the machine, pressing the Play button will start the job. Pressing the Play button eliminates the need
to start the job using the GO key on the Fusion keyboard.
Please be careful when starting a job from the ECC. As you can imagine, if you have a job in queue
without running it and leave the laser unattended briefly, someone else may come along and change
your work piece. If you do not check to make sure it's still in place you would be better off starting
the job from the laser Keyboard.
You can only start a job if the status of the machine is Idle. The job will run using the laser
parameters that are shown. You can also Stop and Pause a job from the computer.
If you have printed a job to the laser and realize that you would like to modify some of the laser
parameters you can change them from the Job tab, click on the Play button and your new settings
will override the old ones.
If you change a laser parameter you can make that change permanent or you can use it as a
temporary setting. If you change the Raster speed you will see the new setting changes to red.
Pressing the Play button will run the job at this new setting, but when the job is finished, the setting
will go back to what was originally sent from the Dashboard driver. To make the change permanent,
first change the setting and then click on Set. The Set button will save the change and the new value
will no longer be red.
The image below shows the Job tab while a job is running. Notice that the status ball has changed to
red. Also notice that the job you are currently running is highlighted in red.
103