Epilog Fusion13000 Owner's Manual page 38

Section 3: Getting Started
Epilog Exhaust Blower Connections
There are two 4" (100 mm) ports attached to the back of the laser system. Attach your
ducting to the machine as shown above.
Check your exhaust system for leaks. Most small leaks can be remedied with
duct tape.
DO NOT OPERATE your laser with inadequate or leaking exhaust.
The drawings below show the typical exhaust setup. The top drawing shows the
exhaust on the roof and the bottom drawing shows the exhaust fan near the
machine. Where the exhaust fan is placed is a choice of personal preference.
Some users like the exhaust fan outside because of noise considerations.
8