Epilog Fusion13000 Owner's Manual page 124

Section 8: Using the Front Control Panel
carriage has stopped, you can open the door to examine the engraving. By closing the door and
pressing the Go key, the engraving / cutting job will commence where it left off. If the item being
engraved is not moved the engraving / cutting registration will not be affected.
Note: Opening to door on the laser during engraving or cutting will stop the laser from firing;
however the lens carriage will continue to move. It is important to STOP the job before you open
the door to ensure the engraving / cutting is completed.
If you press the STOP key while in vector mode it may take some time for the system to actually
stop. The system needs to get to the next node in a vector before it can stop.
RESET:
Pressing the RESET key will move the carriage back to its Home position. Press the RESET button
after you have pressed the STOP button, or after you have moved the carriage when in the Jog
position.
RESET does not erase the job from the laser systems memory; rather it will stop the engraving job
in process and send the carriage back to the home position.
Function Menu:
Job:
94