Epilog Fusion13000 Owner's Manual page 119

Section 7: Quick Start & Easy Setup
WARNING: If you are using Auto Focus and you know there is not enough
clearance between the lens carriage and your material, you will need to lower the
table before you insert your material and start the job. To lower the table, use the
Arrow keys on the keypad to illuminate the light next to the word "Focus". Then
use the Joystick to lower the table enough to accommodate your part.
Note: Please be careful when auto focusing on irregularly shaped items. The
crash bar and air assist tube must clear all edges of the work piece in this situation
also.
Crash bar
The Crash Bar is a safety feature that prevents the table from "crashing" into the
lens carriage and X-beam.
89