Download Print this page

Epilog Fusion Pro 48 Manual

Leveling the table
Hide thumbs Also See for Fusion Pro 48:

Advertisement

Quick Links

www.epiloglaser.com
tech@epiloglaser.com
303-215-9171
Leveling the Table
Fusion Pro 48
Parts Required
Tools Required
5/32" Allen wrench
None
.
02/2023

Advertisement

loading
Need help?

Need help?

Do you have a question about the Fusion Pro 48 and is the answer not in the manual?

Questions and answers

Summary of Contents for Epilog Fusion Pro 48

  • Page 1 303-215-9171 Leveling the Table Fusion Pro 48 Parts Required Tools Required • 5/32” Allen wrench • None 02/2023...
  • Page 2 Leveling the Fusion Pro 48 Table Leveling the Fusion Pro 6. If a front corner appears to be lower than the others, remove the front Table access panel of the engraver: Table level should be checked periodically to ensure that the all areas of the table are the same distance from the focusing lens.
  • Page 3 There are eight (8) leveling points at both the front and rear of the Fusion Pro 48 10. Once the table has been adjusted the engraver. appropriate amount, tighten the two...
  • Page 4 Leveling the Fusion Pro 48 Table 6. Remove the exhaust plenum: Rear Table Adjustment Screws 7. While standing at the rear of the machine and with the focus gauge in contact with the table, move the lens While facing the leveling adjustment carriage between positions 1 and 2.
  • Page 5 Leveling the Fusion Pro 48 Table 6. Remove the exhaust plenum: Table Clamp Locking Screws Position 2 7. While standing at the rear of the machine and with the focus gauge in 9. Once the table clamp locking screws contact with the table, move the lens are loosened, the table can be carriage between positions 1 and 2.
  • Page 6 Leveling the Fusion Pro 48 Table 14. If adjustments are needed to this area Table Leveling Screw Position 2 of the table, repeat the table height adjustment process outlined above to level positions 3 and 4 using the table clamp and leveling screws shown...
  • Page 7 Leveling the Fusion Pro 48 Table Table Clamp Locking Screws Position 4 17. If adjustments are needed to this area of the table, repeat the table height adjustment process outlined above to level positions 5 and 6 using the table...
  • Page 8 Leveling the Fusion Pro 48 Table Table Clamp Locking Screws Position 6 20. If adjustments are needed to this area of the table, repeat the table height adjustment process outlined above to level positions 5 and 6 using the table...
  • Page 9 Leveling the Fusion Pro 48 Table Fine Tuning the Table Level Table Clamp Locking Screw Position 8 1. The autofocus can be used to confirm the quality of the table level. 2. Using the same table locations described above, jog the lens carriage...