Epilog Fusion13000 Owner's Manual page 120

Section 7: Quick Start & Easy Setup
The Fusion keyboard will display the job:
Job: Untitled
Place your work piece in the upper left corner of the engraving table, close the door and then
press the Go key to start the job.
To access the ECC after the job has printed go to your Icon tray in the lower right corner of your
Windows screen and double click on the ECC icon. Once you have opened the ECC from your
desktop you will only be able to access it through the lower right icon tray. If you close the ECC
or it is not in the icon tray go back to your desktop to reopen it. The icon tray is in the lower right
corner of the Desktop and the ECC icon is shown below. You icon tray may look different than
the one shown, but it should be in the lower left corner.
90