Federal Communications Commission (Fcc) Notice - Epilog Fusion13000 Owner's Manual

you notice that the laser operates with a door or window open, please contact Epilog
technical support immediately.
The laser has two basic operating methods. For cutting (vector), the laser is driven
along a path and the laser is left on all the time. The path could be the outline of a
letter or a geometric shape like a circle. The laser will cut entirely through the
material, separating the part from the background. For marking (engraving), the laser
is swept across the work from left to right, and the laser is turned on and off at the
correct points to produce the first line of the image. Then the carriage advances one
line and the process is repeated, eventually assembling a full image.
Federal Communications Commission
(FCC) Notice
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy; and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to correct the
interference at his/her own expense.
Section 16: Specifications
169