Safety; Safety Guidelines; System Set-Up; Mounting Options - Pace ST 25 Operation And Maintenance Manual

Safety

Safety Guidelines

The following are safety precautions that personnel must understand and follow when using or
servicing this product.
1. POTENTIAL SHOCK HAZARD - Repair procedures on PACE products should be
performed by Qualified Service Personnel only. Line voltage parts may be exposed
when the equipment is disassembled. Service personnel must avoid contact with these
parts when troubleshooting the product.
2. To prevent personnel injury, adhere to safety guidelines in accordance with OSHA and
other applicable safety standards.
3. SensaTemp handpiece heaters and installed tips are hot when the handpiece is powered
on and for a period of time after power off. DO NOT touch either the heater or the tip.
Severe burns may result.
4. PACE Tip & Tool Stands and handpiece cubbies are designed specifically for use with
the associated handpiece and houses it in a manner that protects the user from
accidental burns.
handpiece in its holder after use and allow for cooling before storing.
5. Always use PACE systems in a well ventilated area. A fume extraction system such as
those available from PACE are highly recommended to help protect personnel from
solder flux fumes.
6. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the Material
Safety Data Sheet (MSDS) supplied with each chemical and adhere to all safety precautions
recommended by the manufacturer.

System Set-Up

Set up the ST 25 system using the following steps and associated drawings.
1. Store the shipping container in a convenient location. Reuse of these
containers will prevent damage if you store or ship your system.
2. Place the Power Switch in the "OFF" or "0" position.

Mounting Options

The ST 25 can be placed directly on a workbench or it also can also be mounted under a workbench
or shelf to conserve space (optional mounting bracket sold separately). To mount the system in
this way (ST 45 shown):
1. Mount the bracket in the desired location (fasteners not
supplied).
2. Insert the 2 Mounting Screws (head first) into the power
source mounting slots.
3. Place the washers over the screws.
4. Fit the power source between the bracket's support arms
and place the screws into the slots on the support arms.
5. Place the nut on the screw and tighten by hand.
6. Angle the power source so the operator can see the front
panel easily.
7. Tighten the nuts with a wrench or pliers.
©2004 PACE Inc., Annapolis Junction, Maryland
All Rights Reserved
Always store the handpiece in its holder. Be sure to place the
Page 5 of 11