LifeSpan Flare Owner's Manual page 35

E4 or E5 Incline failure
E3 Overload protection
E07 Computer EEPROM
read-write error
Motor not functioning
after pressing START
button
1. Check incline motor wiring.
2. Check AC lines wire of motor is properly connected, and if the
motor AC wire is inserted properly with correct sign on control
board.
3. Check connection line of motor to see if it is destroyed,
exchange it or incline motor. And press "learning" button of
bottom control board to relearn upon completion of checks.
1. Upon overload, the system will restart to prevent damage. If the
treadmill gets stuck and the motor cannot move it will lead to an
overload. Please locate the cause of this. A possible reason is a
lack of lubricant in a particular component. Then restart the
machine.
2. Check if the motor sounds like its being over worked or for a
burning smell. If so, change motor
3. Check control board. If control board is emitting a burning smell,
change it.
1. Change computer EEPROM
1. the motor wire is broken; the safety pipe is broken or has fallen
off;
2. motor wire is not properly connected
3. IGBT on bottom control board is burnt out. Test the above
reasons and change the relevant part.
35
FLARE