Scan Function; Scan Mode; Reception On Preset Frequency In Scan Mode - Becker AR6201 Installation And Operation Manual

AR6201-(X0X)
3.5.4

Scan Function

In all Frequency Selection Modes, a long press of "↕/SCN" key activates
the Scan Function and change to STANDARD MODE if activated from CHANNEL
or DIRECT TUNE Mode.
A short push on the "MDE" key, or a long press on "SCN" key terminates
Scan Function. After leaving Scan Function, the device will remain in
Standard Mode.
Simultaneously indicated on the display appears the Active Frequency on
the top line and the Preset Frequency on the bottom line. The SCAN sign
in the display indicates that Scan Function is active.

SCAN Mode

While Active Frequency and Preset Frequency detected a signal
simultaneously, the Preset Frequency inverts and blinks. The Active
Frequency has priority. The arrow sign "►" in front of the Active
Frequency indicates audio from Active Frequency is audible. A sample
display shows the picture below.
Blinking
An audio notification "Beep" tone, if selected in the Installation
Setup, additionally to the blinking Preset Frequency notifies the
presence of an RX signal on the Preset Frequency.
If Preset Frequency detects an RX signal while on the Active Frequency
no signal is present, the transceiver automatically switches over to the
Preset Frequency. The arrow sign now appear in front of the Preset
Frequency and the signal is audible. A sample display shows the picture
below.

Reception on Preset Frequency in Scan mode

Disabling Squelch in Scan Function provides audio of the Active
Frequency to the audio output all the time, regardless of the presence
of RF signal on Active Frequency or Preset Frequency).
Page 3-10 DV 14300.03/.04 Issue 5 5/2013