Pilots Menu; Brightness - Becker AR6201 Installation And Operation Manual

Note: In installation with the second controller (see Figure 2-11),
AR6201-(X0X) adjusts VOX threshold for Microphone 1 only,
RCU6201 adjusts VOX threshold for Microphone 2 only (see
description of /MIKE_SW pin in chapter 2.4.2).
An adjustment of the VOX threshold level is not possible if VOX forced
to be "OFF" (due to Enabled speaker in current Audio Configuration).
By changing the VOX threshold level to above +10, VOX can be switched
"OFF". In this case, "OFF" replaces the numerical value indication (see
figure below):
If VOX switched "OFF", activation of intercom operation by the external
intercom switch (/IC discrete input) is possible at any time.

3.13.2 Pilots Menu

Make a two seconds press on the "MDE" key to enter the Pilots Menu.
The Pilots Menu can be left by a two seconds press again on the "MDE"
key, or left automatically after a few seconds, or after a short push on
the "ROTARY ENCODER" when SQUELCH setting page is visible.
The Pilots Menu consists of two pages:
- BRIGHTNESS (first page)
- SQUELCH (second page)
Toggling between the pages is provided by a short press on the "MDE"
key, or by a short press on the "ROTARY ENCODER".

BRIGHTNESS

The Active Frequency stays indicated in the top line of the display.
Underneath the Active Frequency, the "BRIGHTNESS" label appears in
combination with a bar graph including a figure for the selected value.
The panel brightness for display illumination and pushbuttons can be
changed from 0 to 100 by turning the "ROTARY ENCODER". Adjustment 0
means illumination is turns "OFF" completely and 100 means the
illumination is at maximum.
DV 14300.03/.04 Issue 5 5/2013
AR6201-(X0X)
Page 3-17