Installation Setup Pages – Data Description - Becker AR6201 Installation And Operation Manual

2.8.5 Installation Setup Pages – Data Description
Display Contents
Select your option by turning
the "ROTARY ENCODER" and press
"STO" push-button to finalize
the selection.
Note:
This page is displayed only if
dimming bus is set to "NONE",
otherwise the pages of "ILLUM
CURVE" adjustment will be
accessible.
DV 14300.03/.04 Issue 5 5/2013
AR6201-(X0X)
Description
After initiating the "Installation Setup" the
first page will be displayed. This page shows
information about the SW version and the serial
number of the transceiver.
One of the three following options may be
selected to dim the display and push-button
background lighting:
NONE:
The illumination for LCD and push-buttons is
controlled via the "ROTARY ENCODER" of the
AR6201-(X0X). The Pilot can change the
brightness in the Pilots Menu (refer to chapter
3.13.2). Dimming via the "ROTARY ENCODER" is no
longer available after selecting one of both
options below.
0-14V:
The background lighting for LCD and push-buttons
is controlled (via pin P1-10/P1-23) by the
dimming bus of the aircraft.
The dimming curve will be adjustable within the
range from 0 ... 14 V DC
0-28V:
The background lighting for LCD and push-buttons
is controlled (via pin P1-10/P1-23) by the
dimming bus of the aircraft.
The dimming curve will be adjustable within the
range from 0 ... 28 V DC
The brightness of the LCD and push-button
illumination is adjustable between 0% and 100%.
Note: The same adjustment is also possible in
the pilot´s setup menu. Pilots can change the
parameter at any time.
Select your brightness by turning "ROTARY
ENCODER".
Page 2-19