Installation - JVC HR-S9600EK Instructions Manual

6
2

INSTALLATION

CONNECT VIDEO RECORDER TO TV
Place the recorder on a stable, flat surface.
Back of TV
Aerial connector
21-pin AV input connector
(SCART)
Mains Power Cord
Mains outlet
RF CONNECTION
To connect to a TV with NO 21-pin AV input connector
(SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the RF OUT jack on
the rear panel of the recorder and the TV's aerial connector.
AV1 INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNECTION
The AV1 IN/OUT connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in
which the luminance and chrominance signals are separated). For input signal selection, select "VIDEO" (regular video signal) or
"S-VIDEO" (Y/C signal) for "AV1 SELECT" setting (
If your TV's 21-pin AV input connector (SCART) is compatible only with the regular video signal, set this switch to COMP.
If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set this switch to Y/C. You can obtain high-
quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)
NOTES:
Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.
For switching the TV's mode, refer to the instruction manual of your television.
To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 7.
ATTENTION
Do NOT Plug the mains power cord into a mains outlet until all connections are completed.
Do NOT press the
power before you start the Auto Set Up procedure described on page 8.
21-pin SCART Cable (not provided)
Make this
connection if
your TV has a
21-pin AV input
connector (SCART)
in order to reduce
the possibility of
interference. And if you are
using a stereo TV, you will
need this cable in order to enjoy
stereo playback of videotapes.
pg. 40). For output signal selection, use AV1 OUT switch of the rear panel.
button on the recorder or on the remote control to turn on the recorder's
QUICK SET UP GUIDE (cont.)
RF Cable (provided)
AV1 OUT
S OUT
AV1 IN/OUT
COMP. Y/C
AV2 IN/DECODER
AV1 OUT switch
AV CONNECTION
To connect to a TV with 21-pin AV input connector (SCART) . . .
1– Connect the aerial, recorder and TV as per "RF CONNECTION".
2– Connect an optional SCART cable between the AV1 IN/OUT
socket on the rear panel of the recorder and the TV's 21-pin
AV input connector (SCART).
3– Set the AV1 OUT switch to the appropriate position. See "AV1
INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNEC-
TION" below.
TV Aerial Cable
(not provided)
SYNCHRO EDIT
JLIP
ANT. IN
L
AUDIO
OUT
R
PAUSE/R.A. EDIT
RF OUT
Back of Recorder