Digital Video Cassette Technology
Software Installation
Use the following procedure to install the JVC Service Support System software.
Insert the Floppy Disk containing the software into the computer's Floppy
1.
Disk Drive.
Using the Windows® Explorer or File Manager locate the Setup application
2.
on the Floppy Disk.
Run the Setup application.
3.
Figure 1 Setup Application
At the end of the installation the final screen prompts you to open the
4.
readme file. Click the check box before you click the Finish button. Read
the readme file when it is displayed.
After you have read the readme file, select Exit from the File menu to close
5.
the file.
Camera Connection
Connect the camera to the computer.
Connect the PC Cable's, P/N QAM0099-002, DSUB-9 plug to a free serial
1.
communications port on the computer. Make a note of which port you used.
Connect the cable's 3.5 mm diameter plug to the JLIP Connector on the
2.
camera. The location of the connector varies according to model. Use the
appropriate figure as a guide for the connector's location.
4