Standby/On Recorder - JVC HR-S9600EK Instructions Manual

* CABLE/SAT Button enables remote control of
connected satellite receiver.
"Remote Control LCD" in the right column
( STANDBY/ON
recorder.
) – –:– – (DISPLAY) Button switches display
between clock time, tape remaining time,
counter readings and preset position*.
* Preset position is not displayed during playback.
q TV/VCR Button — same as button on recorder.
pg. 12
w REVIEW Button — same as button on recorder.
pg. 25
e 30 SEC Button initiates a 30-second period of
fast-motion playback.
r WEEKLY Button — same as button on recorder.
pg. 17, 19
Button transmits entered PlusCode number to
t
the recorder. pg. 16
y AUX Button selects recorder's auxiliary input
mode. pg. 36, 37, 38
u ‰ (TIMER) Button — same as ‰TIMER button
on recorder. pg. 17, 19
i Auto Tracking Button (
auto tracking mode during playback
SP/LP Button selects tape speed.
o OK Button — same as button on recorder.
pg. 21
p MENU Button accesses Menu screen.
Q TV PROG +/– Button — same as button on
recorder. pg. 14
W DATE +/– Button — same as button on
recorder. pg. 18
E Fast Forward [FF] Button — same as button on
recorder. pg. 12, 13
R Stop Button — same as button on recorder.
pg. 12
T Pause Button — same as button on recorder.
pg. 13
@ #
Y Button initiates functions such as Index
Search pg. 25, variable-speed search, frame
by frame playback.
TV +/–Button controls volume of connected
TV. pg. 33
pg. 34,
Button — same as button on
pg. 25
) enables/disables
pg. 24
pg. 14
pg. 12, 26
How To Use
The remote control can operate most of your video
recorder's functions, as well as basic functions of TV sets
and satellite receivers of JVC and other brands.
( pg. 33, 34)
Point the remote control toward the sensor window.
The maximum operating distance of the remote control
is about 8 m.
pg. 15
NOTES:
When inserting the batteries, be sure to insert in the
correct directions as indicated under the battery cover.
If the remote control doesn't work properly, remove its
batteries, wait a short time, replace the batteries and then
try again.
Remote Control LCD
The remote control can operate not only the video
recorder but also some of your TV and satellite receiver's
functions. The LCD indicates which of these (VIDEO, TV
or CABLE/SAT) the remote control can currently operate.
When you first purchase the remote control, or after you
have just replaced the batteries, VIDEO A (A code) is
selected.
1 To operate your video recorder, first press the VCR
button to set the remote control to the Video mode.
To switch remote control's A/B code, refer to page 32.
2 To operate your TV, first press the TV button to set the
pg. 21
remote control to the TV mode (
3 To operate your satellite receiver, first press the CABLE/
SAT button to set the remote control to the Satellite
receiver mode (
NOTES:
Even if "TV" is displayed on the LCD, the following
operations can be performed without switching the mode.
Basic operations for the recorder
After an operation is completed, "TV" reappears on the
LCD.
Express Timer Programming and VIDEO Plus+ Timer
Programming operations
To perform a TV operation again, switch to TV mode
first.
Accessing main menu
To perform a TV operation again, switch to TV mode
first.
pg. 33).
pg. 34).
71