Table of Contents
Advertisement
IN STALLATIO N
2
CO N N ECT VID EO RECO RD ER TO TV
Place the recorder on a stable, flat surface.
Back of TV
Aerial connector
21-pin AV input connector
(SCART)
RF CO N N ECTIO N
To connect to a TV with NO 21-pin AV input connector
(SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the RF OUT jack on
the rear panel of the recorder and the TV's aerial connector.
ATTEN TIO N
Do NOT Plug the mains power cord into a mains outlet until all connections are completed.
Do NOT press the
power before you start the Auto Set Up procedure described on page 6.
Downloaded from:
https://www.usersmanualguide.com/
21-pin SCART Cable (not provided)
Mains Power Cord
Mains outlet
button on the recorder or on the remote control to turn on the recorder's
RF Cable (provided)
Make this
connection if
your TV has a
21-pin AV input
connector (SCART) in
order to reduce the
possibility of interference.
And if you are using a stereo
TV, you will need this cable
in order to enjoy stereo
playback of videotapes.
AV1 IN/OUT
AV2 IN/DECODER
AV CO N N ECTIO N
To connect to a TV with 21-pin AV input connector (SCART) . . .
1– Connect the aerial, recorder and TV as per "RF CONNECTION".
2– Connect an optional SCART cable between the AV1 IN/OUT
socket on the rear panel of the recorder and the TV's 21-pin
AV input connector (SCART).
AFTER YOU FINISH THIS STEP
TV Aerial Cable
(not provided)
SYNCHRO EDIT
JLIP
ANT. IN
L
AUDIO
OUT
R
PAUSE
RF OUT
Back of Recorder
Go to Step 3 – AU TO SET U P
5
Advertisement
Table of Contents
