Audio Dubbing - JVC HR-S9600EK Instructions Manual

Audio Dubbing

CD Player etc.
Mixer
output
1 3
2
NOTES:
When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the mixed sound (Hi-Fi + Normal soundtracks), press
AUDIO on the remote control to select "
NORM" ( pg. 29).
Audio dubbing stops automatically when the counter reaches
"0:00:00", and the recorder enters the Play mode. Check the
counter reading before dubbing.
Audio dubbing is also possible using the rear panel AV1 IN/OUT
or AV2 IN/DECODER connector. When using these connectors,
make sure to select the correct input mode in step 2.
Audio dubbing cannot be performed on a cassette that has
had its record safety tab removed.
When playing back an audio-dubbed tape, press AUDIO on
the remote control to select the soundtrack you wish to hear
( pg. 29).
CD Player etc.
Audio mixer
Original sound
AUDIO OUT
+ (L+R) +
Audio dubbing replaces the normal audio sound of a previously
recorded tape with a new soundtrack.
Normal audio track
Video/Hi-Fi audio
track
MAKE CONNECTIONS
1
Connect an audio component to the AUDIO L + R
connectors on the recorder's front panel.
When connecting monaural equipment, use only the
recorder's AUDIO L connector.
SET INPUT MODE
2
Press NUMBER key "0" and/or TV PROG so that "F-1" or
"S-1" appears in place of a channel number.
LOCATE START POINT
3
Press PLAY to start playback of the tape in your
recorder, and press PAUSE when you find the point
where you want to start dubbing.
ENGAGE AUDIO DUBBING
4
Press A. DUB.
It is possible to take the original sound recorded on
the tape in your recorder and mix it with other
sounds from a microphone, CD player etc. To
perform this audio dubbing with audio mixing,
connect as in the diagram on the left.
Your recorder enters the Audio Dubbing Pause mode.
(" " blinks, " " and " " light up on the front display
8
panel.)
To perform audio dubbing with audio mixing, press
AUDIO MONITOR (or AUDIO on the remote
control) to select "
* Audio dubbing with audio mixing is not possible if
you're using a monaural audio component, or if
you don't have an audio mixer.
START DUBBING
5
Engage the audio component's Play mode, then press
PLAY to start the tape in your recorder. Audio dubbing
begins at this point.
" " blinks and " " is displayed on the front display
panel.
To stop dubbing temporarily, press PAUSE. Press
PLAY to resume dubbing.
END AUDIO DUBBING
6
Press STOP to stop the tape in your recorder, and
engage the audio component's Stop mode.
41
Pre-recorded tape
Audio-dubbed tape
+ (L+R)" at this point.