Operating Mode Description - MPP Solar PIP-MS 1-5KVA User Manual

Operating Mode Description

Operation mode
Standby mode / Power
saving mode
Note:
*Standby mode: The inverter is
not turned on yet but at this
time, the inverter can charge
battery without AC output.
*Power saving mode: If
enabled, the output of inverter
will be off when connected load
is pretty low or not detected.
Fault mode
Note:
*Fault mode: Errors are caused
by inside circuit error or external
reasons such as over
temperature, output short
circuited and so on.
Fault mode
Note:
*Fault mode: Errors are caused
by inside circuit error or external
reasons such as over
temperature, output short
circuited and so on.
Line Mode
Description
No output is supplied by the
unit but it still can charge
batteries.
PV energy and utility can
charge batteries.
Utility can power loads when
the unit starts up without
battery. (Only available in
4K/5K model with single
operation)
The unit will provide output
power from the mains. It will
also charge the battery at
line mode.
LCD display
Charging by utility.
Charging by PV energy.
No charging.
Charging by utility. (Only available in 1K/2K/3K
model)
Charging by PV energy.
No charging.
Power from utility
Charging by PV energy
Charging by utility.
24