Table of Contents
Advertisement
Signamax
„§
065
Connection to Data Terminal
Equipment (DTE)
Console Mode
1. Ensure that DIP switch #1 is in the "ON" position.
(Enables Console mode)
2. Set DIP switches #2, #3 and #4 according to the wire type
as indicated below:
RS-232
4-wire
(RS-422/485)
2-wire (RS-485)
3. Prepare TIA/EIA-574 compliant 'cross-over' shielded
cables with DB-9 connectors.
4. Connect male DB-9 connector at one end of the cable to
the converter's female DB-9 connector.
5. Connect male or female DB-9 connector at other end of
the cable to the DTE's male or female DB-9 connector.
6. Once the device is connected, proceed to configure the
media converter by using the on-screen menu.
-1163T RS-232/422/485 to 10/100BaseT/TX Media Converter
Installation
DIP 2
DIP 3
ON
OFF
OFF
ON
OFF
OFF
DIP 4
OFF
OFF
ON
9
Advertisement
Table of Contents
