Table of Contents
Advertisement
Signamax
„§
065
From this screen, specify the IP address of the remote
media converter to which the connection is being made.
(The TCP port number is a number from 1024 to 65535).
**NOTE: Local and remote media converters must have the same
TCP port number in order for a connection to occur.
The Connection Idle Time field becomes active when there
is no traffic passing through the media converter. Set the
idle time value between 30 and 3600 seconds and when
this time has been reached, the connection will be
terminated automatically.
Under the Serial Port Configuration heading, the field
Operation Mode is a "read only" value indicating one of the
following modes: Console, RS-232, RS-422, or RS-485.
The mode is based on the DIP switches setting found on the
rear panel of the media converter.
Other fields that can be modified from this screen are:
communication data baud rate, parity, word length, stop bits
and flow control. Defaults for these are below:
• Baud rate – 38400
• Parity – N
• Word length – 8
-1163T RS-232/422/485 to 10/100BaseT/TX Media Converter
Configuration
20
Advertisement
Table of Contents
