Table of Contents
Advertisement
Signamax
„§
065
-1163T RS-232/422/485 to 10/100BaseT/TX Media Converter
4
Configuration
There are two separate methods for configuring this media
converter for use. In the first section of this chapter, the
Command line Interface (CLI) or Menu-driven interface via
the Console Port to set the device for connection to data
terminal equipment in console mode will be defined. The
second section will describe the CLI or Menu-driven via
Telnet configuration.
Console Port
The media converter is accessible via a terminal emulator
attached to the RS-232 console port. After completing the
steps outlined to connect the devices (see Connection to
Data Terminal Equipment in the previous chapter), proceed
with the directions below to log in to the management facility
using a HyperTerminal.) The converter is preset with a
factory IP address that must be configured to the user's
individual IP address. It is important to do this so that the
converter doesn't conflict with other devices with the same
defaults.
Configuration
14
Advertisement
Table of Contents
