Steps For Finalizing The Installation - Travis Industries 564 HO GS Installation Manual

Steps for Finalizing the Installation

1. Remove the glass (see page 39).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected
once it enters the firebox, ensuring gas does not build up.
3. Make sure the two accent light bulbs are in place.
NOTE: Take care to not touch the bulb with your fingers (use a cloth or paper towel).
4. Install the four AA batteries (included in the owner's pack) into battery holder (see the illustration below). The AA
batteries act as a power backup in case the household (AC) power goes out. Install the 9v battery (included in
the owner's pack) into control panel light assembly (see the illustration below). The battery holder is held in
place with Velcro and may be removed for easier access.
Lift up and swing the lower
grill down to acces the area
below the firebox.
5. Install the Burner/Logs Kit (see the Burner instructions).
6. Replace the glass.
7. Start the heater.
8. Leak test all gas joints.
© Travis Industries
Installation
(
Swing the concealment
cover up and slide it back to
expose the controls.
for qualified installers only)
AA Battery Tray
4110505
Battery Holder for
Control Panel Lights
AA
Battery
Holder
100-01263_000
37