Table of Contents
Advertisement
Steps for Finalizing the Installation
1. Remove the glass (see page 21).
NOTE:
If using propane (LP) convert the appliance prior to installing the media.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3. Make sure the accent light bulbs are in place and work correctly.
NOTE: Take care to not touch the bulb with your fingers – use a cloth or paper towel).
4. Install the four AA batteries in the remote receiver (included in the owner's pack - see illustration
below). The AA batteries act as a power backup in case the household (AC) power goes out and are
required for operation. Install three AAA batteries into the remote (see illustration below).
Synchronize the transmitter to the receiver (see page 30).
T he remote
us es 3 AAA
batteries .
5. Install the media (see the instructions included with the media kit).
6. Replace the glass.
7. Start the heater.
8. Leak test all gas joints.
9. Adjust the air shutter following the directions on the next page.
10. Attach the face following the directions included with the face.
11. Adjust the flame to its highest position - the flames should not contact the top of the firebox. Check the flame
on low position. The flames should burn off of each burner hole. If the heater does not work correctly,
contact your Travis dealer for a remedy.
© Travis Industries
Finalizing the Installation
4051112
T he remote receiver
us es 4 AA batteries .
100-01271_000
25
Advertisement
Table of Contents
