Steps For Finalizing The Installation - Travis Industries DVL GSR2 NB Owner's Manual

24

Steps for Finalizing the Installation

1. Remove the glass (see page 22).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected
once it enters the firebox, ensuring gas does not build up.
3. Make sure the accent light bulbs are in place and work correctly.
NOTE: Take care to not touch the bulb with your fingers – use a cloth or paper towel).
Rear Accent Light
4. Install the four AA batteries (see illustration below). The AA batteries act as a power backup in case the
household (AC) power goes out and are required for operation.
illustration below). Synchronize the transmitter to the IFC (see page 27).
© Travis Industries
Finalizing the Installation
4140813
Firebox Ceiling Accent Light
Install three AAA batteries into the remote (see
100-01294