Pressure Rollers; Power Inlet - Contex XD2490 Service Manual

Pressure Rollers

*Switch Scanner off and disconnect from power source and PC prior to any repair.

Power Inlet

*Switch Scanner off and disconnect from Power source and PC prior to any repair
Remove RHS cover, see page 4-5
4-12
Part replacement MG52D Part replacement MG52D
1. Press lock tabs in.
2. Push Power entry module slightly out.
Repeat the for other side and pull out
module and disconnect cables.
Install the new Power Entry module reverse
the steps.
1. Remove screws and pull out
Pressure Roller cover.
1. Pull out Pressure Roller.
Replace Pressure Roller and reverse
the steps.
4-12