Installation; Installing Dealer/Contractor Responsibilities; Delivery Inspection - Briggs & Stratton Home Generator System Installation & Start-Up Manual

Installation

Equipment Description
This product is intended for use as an optional residential
generator system which provides an alternate source
of electric power and to serve loads such as heating,
refrigeration systems, and communication systems that,
when stopped during any power outage, could cause
discomfort or inconvenience. This product does not qualify
for emergency standby as defined by NFPA 70 (NEC).
Every effort has been made to ensure that information in this
manual is accurate and current. However, we reserve the
right to change, alter, or otherwise improve the product and
this document at any time without prior notice.
Only current licensed electrical and plumbing
professionals should attempt home generator system
installations. Installations must strictly comply with all
applicable codes, industry standards and regulations.
Home Owner Responsibilities
• Read and follow the instructions given in the
operator's manual.
• Follow a regular schedule in maintaining, caring for
and using your home generator, as specified in the
operator's manual.
If you have questions about intended use, ask your installer
or dealer or call (800) 743-4115 between 8:00 AM and
5:00 PM CT.

Installing Dealer/Contractor Responsibilities

• Read and observe the safety rules.
• Install only an UL approved transfer switch that is
compatible with the generator.
• Read and follow the instructions given in this
installation and start-up manual.
If operating the generator below 40° F (5° C), it is HIGHLY
RECOMMENDED that a Model 6030 Cold Weather Kit
(includes oil warmer and battery warmer) and a Model
6174 Cold Weather Breather Kit (includes engine duct)
be installed. These items are available at your local
servicing dealer.
Unpacking Precautions
The unit is shipped bolted to its mounting pad, ready
for installation. Avoid damage from dropping, bumping,
collision, etc. Store and unpack carton with the proper side
up, as noted on the shipping carton.

Delivery Inspection

After removing the carton, carefully inspect the home
generator for any damage that may have occurred
during shipment.
If loss or damage is noted at time of delivery, have the
person(s) making delivery note all damage on the freight
bill and affix his signature under the consignor's memo of
loss or damage. If loss or damage is noted after delivery,
separate the damaged materials and contact the carrier
for claim procedures. Missing or damaged parts are
not warranted.
Shipment Contents
The generator is supplied with:
• Pre-attached mounting pad
• Fully-serviced oil/lubricating system
• Flexible fuel hook-up hose
• Installation and start-up manual
• Operator's manual
• Engine operator's manual
• Installation checklist
• Spare access door keys
• Spare 15 Amp ATO-type fuse
• Two-pin control panel connector
• Ten-pin control panel connector
• Touch up paint
• Remote LED indicator kit (LED/plate/screws)
Not Included:
• Starting battery (see page 15)
• Connecting wire and conduit
• Fuel supply valves/plumbing
• Crane, lifting straps, chains or cables
• Two 48" lengths of 1" pipe (NOT conduit)
• Hole punches for 16ga steel
• Torque screwdriver, 5 to 50 inch-pound range
• Voltage/frequency meter
• Various special tools and equipment
7