Throttle Cable Adjustment - Yamaha 40V Service Manual

INSP
ADJ
CONTROL SYSTEM
Loosen the lock nut 2.
Disconnect the magneto control rod 3
at the CDI unit.
Turn the magneto control lever so that
its adjusting screw contacts the full
retarding stopper b.
Adjust the magneto control rod length
so that the CDI unit indicator aligns
with the specified marking on the
plate.
Full retarded position:
ATDC 7˚
Connect the magneto control rod.
Turn the magneto control lever so that
it contacts the full advance adjusting
screw 4 .
Adjust the full advance adjusting
screw so that the CDI unit indicator
aligns with the specified marking on
the plate.
Full advanced position:
BTDC 25˚

Throttle cable adjustment

NOTE:
Before adjusting the throttle cable, the
throttle link should be adjusted.
1. Check:
Full-open position
Incorrect → Adjust.
Checking steps:
Set the shift lever to the forward posi-
tion.
Open the throttle grip fully.
Check the throttle valve lever so that it
contacts the full opening stopper.
2. Adjust:
Throttle cable joint position
Adjustment steps:
Loosen the lock nut 1.
Remove the clip 2.
Disconnect the cable joint at the mag-
neto control lever.
Close the throttle grip fully.
3-3
E