GEN
INFO
SAFETY WHILE WORKING
3. Non-reusable items
Always use new gaskets, packings, O-
rings, split-pins and circlips etc. on
reassembly.
DISASSEMBLY AND ASSEMBLY
1. Clean parts with compressed-air on dis-
assembling them.
2. Oil the contact surfaces of moving parts
on assembly.
3. After assembly, check that moving
parts operate normally.
4. Install bearings with the manufacturer's
markings on the side exposed to view,
and liberally oil the bearings.
5. When installing oil seals, apply a light
coating of water-resistant grease to the
outside diameter.
1-4
E