Nikon D300 User Manual page 598

Interestingly, when you have
selected, you can hold down the
front Sub-command dial
PRE-measured white balances (d-o to d-4). See the
upcoming chapter titled
the PRE (PrE)
▪ D – (D300S only) This symbol represents the volume
control for the built-in mono microphone or externally
mounted stereo mic. To use this setting, hold down the
Playback button
(normally used to view images), and press left on the
Multi Selector. This surrounds the symbol with a yellow
square, letting you know it is selected. Once you have it
selected, you can hold down the
press up or down on the
the volume levels on the microphone. Your choices are
A (Auto), 1, 2, 3, and Off.
▪ E – (D300S only) This symbol shows the minutes and
seconds when you are recording a video in
mode. It isn't directly related to
D-Movie mode uses the
for immediate use. If you press the
button to start a video recording, you'll see this symbol
start counting down the minutes and seconds. When
you're recording a video, a big red dot followed by REC
will flash in the upper-left corner of the Monitor.
▪ F – This symbol represents the
is only seen when you press the
View mode. To access the setting—if the microphone
volume control is selected on the D300S (see D)—hold
down the Playback button
to select one of the five stored
Chapter 10
method, and other WB settings.
on the top rear left of the camera
Multi Selector
Live View
and scroll right with the
598
PRE White balance (PrE)
WB button and turn the
to better understand
Playback button
to scroll through
Live View, but since
display, it is ready
Multi selector center
Monitor brightness and
Playback button
and
D-Movie
in Live
Multi