Connecting Other Equipment - JVC UX-A70MDR Instructions Manual

To connect speakers
You can connect the speakers using the speaker cords.
1
2
Speaker terminals
Speaker cord
+
R
-
R
Rear of the right
speaker
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: White (+)
to red (+) and black (–) to black (–).
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
3,4
Red
Speaker cord
+
L
-
Black
L
Rear of the left
speaker

Connecting Other Equipment

You can connect the following equipment which can be
used as a playback and recording device. By using the
cassette deck, for example, you can record any source
played back on this unit.
When you connect and use the equipment, refer also to its
manual supplied.
• DO NOT connect other equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect another component such as a cassette
deck
Be sure that the plugs of the audio cords and the jacks on
the rear of the unit are color-coded: White plugs and jacks
are for left audio signals, and red ones for right audio
signals.
Ex. Cassette deck
ANTENNA
AM EXT
AM LOOP
FM(75 )
COAXIAL
By using audio cords (not supplied), connect:
• Between the audio input jacks on the cassette deck and
the LINE OUT jacks — For recording on the cassette
deck.
• Between the audio output jacks on the cassette deck and
the LINE IN jacks — For playing a tape.
– 8 –
Continued
To output (PLAY)
To input (REC)
–