Adjusting The Volume; Reinforcing The Bass Sound; Selecting The Sound Modes - JVC UX-A70MDR Instructions Manual

Adjusting the Volume

You can adjust the volume level only while the unit is
turned on.
To decrease the volume, press VOLUME – .
To increase the volume, press VOLUME + .
• When press and hold each button, you can change the
volume level continuously.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
If "CAN NOT LISTEN" appears in the main display
During high-speed recording (see page 30), you cannot listen to
any source, and therefore, cannot adjust the volume level.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, the
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is in standby mode.
To turn down the volume level temporarily
On the remote control ONLY:
Press FADE MUTING.
The unit automatically decreases the volume level to
"VOL.MIN" at once.
To restore the sound, press FADE MUTING again.

Reinforcing the Bass Sound

The richness and fullness of the bass sound is clearly
maintained regardless of how low you set the volume —
Active Hyper Bass PRO.
• You can use this effect only for playback.
To get the effect, press AHB PRO.
"BASS ON" appears in the main display and the BASS
(VOL. 40)
indicator lights on the display.
To cancel the effect, press AHB PRO again.
"BASS OFF" appears in the main display and the BASS
(VOL. 0)
indicator goes off from the display.

Selecting the Sound Modes

You can select one of the 3 preset sound modes. The sound
modes can be applied only to playback sounds, and cannot
be used for recording.
On the remote control ONLY:
To select the sound modes, press SOUND MODE
repeatedly until the sound mode you want appears in the
main display.
The SOUND indicator also lights on the display.
• Each time you press the button, the sound mode changes
as follows:
ROCK:
POP:
CLASSIC:
FLAT:
To check the sound mode currently selected, press
SOUND MODE once while the SOUND indicator is lit.
The currently selected sound mode will appear in the main
display.
– 12 –
FLAT
ROCK
(Canceled)
Boosts low and high frequency.
Good for acoustic music.
Good for vocal music or voice.
Good for classical music.
Cancels the sound mode.
CLASSIC
POP