Setting The Display Illumination - JVC UX-A70MDR Instructions Manual

Setting the Display Illumination

You can change the illumination color and brightness of the
electronic swing panel and display window.
To set the illumination color
You can select the illumination color by your preference.
1
Press to turn on the unit.
2
Press COLOR repeatedly until the color you want
appears in the main display.
• Each time you press the button, the illumination color
changes as follows:
*
(white)
(purple)
Ex. Both "M1" and "M2" are set to "R0 G1 B1" at the
shipment (see also the right column.)
* If you select "RANDOM," the unit will select one
from 9 preset colors at random as the illumination
color every two seconds automatically.
** If you select "M1" or "M2," you can use a custom
color. See "To create your favorite colors" to the
right.
More on the display color
• The colors shown in the display cannot always be reproduced
precisely. Due to the circumstances (room temperature, etc.)
where the unit is used, colors may vary slightly.
• When you change the color of the display, the display may seem
to move back and forth; this is a characteristic of this unit and is
not a malfunction.
• When a strong light strikes the display, the display happens to
become dark, but this is not a malfunction.
(blue) (light blue)
**
(green)
**
(yellow)
(orange)
(pink)
(red)
To create your favorite colors
You can create two favorite colors and store them in
memory as "M1" and "M2."
On the remote control ONLY:
1
Press to turn on the unit.
2
Press COLOR repeatedly until "M1" or "M2"
appears in the main display.
The value of "R (red)" starts flashing.
Ex."M1" is selected. "M1" is already set to "R (red) 0
G (green) 1 B (blue) 1."
3
To adjust the brightness of each color
1) Press Ø and ø to select the color you want to
adjust.
2) Press ¢ or 4 repeatedly to adjust the value
of the brightness (between 0 – 6.)
• As you increase the number, the color becomes
brighter.
3) Repeat steps 3 –1) and 3 –2) to find your favorite
color.
4
Press SET while flashing.
"MEMORY" appears in the main display and the
setting is finished.
• Even if you do not press SET, the unit will finish the
color setting mode automatically.
To dim the display illumination
To dim the brightness, press DIMMER.
• When you press DIMMER while the illumination color
is set to "M1" or "M2," the illumination color is changed
to light blue.
To resume the brightness, press DIMMER again.
– 13 –