Tuning In A Station; Presetting Stations - JVC UX-A70MDR Instructions Manual

Tuning in a Station

1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM–MW/LW.)
• Each time you press the button, the band alternates
between FM and AM (MW/LW.)
2
Press and hold ¢ or 4 until the station
frequencies start changing continuously in the main
display.
• ¢ : to increase the frequencies.
• 4 : to decrease the frequencies.
The unit starts searching stations and stops when a
station of sufficient signal strength is tuned in.
Ex. An FM station is tuned in.
• If an FM program is broadcast in stereo, the STEREO
indicator lights on the display.
To stop during searching, press ¢ or 4.
When you repeatedly press ¢ or 4
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive,
you can change the FM reception mode to improve the
reception.
On the remote control ONLY:
Press FM MODE.
• Each time you press the button, FM reception mode
alternates between "STEREO" and "MONO."
STEREO : Normally select this.
In this mode, you can hear stereo sound
when a program is broadcast in stereo. In
addition, static noise between stations
will be erased while tuning.
MONO : Select this when an FM stereo broadcast
is noisy or hard to receive. Reception
improves though stereo effect is lost.
The MONO indicator lights on the
display.

Presetting Stations

You can preset 30 FM and 15 AM (MW/LW) stations
manually.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the remote control ONLY:
1
Tune in the station (either FM or AM–MW/LW) you
want to preset.
• See "Tuning in a Station" to the left.
2
Press SET.
The preset number starts flashing as follows:
• When you select an FM station in step 1
• When you select an AM (MW/LW) station
in step 1
• The unit always starts from the preset number 1.
3
Press the number buttons to select a preset number.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
For preset number 30, press +10, +10, then 10.
• You can also select the preset number by pressing
¢ or 4.
4
Press SET again.
"STORED" appears in the main display for a while.
The tuned station in step 1 is stored in the preset
number selected in step 3 .
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The FM and AM (MW/LW) preset stations will be erased. If this
happens, preset the stations again.
– 15 –