Table of Contents
Advertisement
PROPAK6 MOUNTING
Use brackets and screws provided with the ProPak6 to facilitate mounting the receiver to a surface. Prior
to connecting any cables and installing the ProPak6 in a fixed position, attach the supplied mounting
brackets to the ProPak6.
High Vibration ProPak6 Mounting
For high vibration installations, mount the ProPak6 directly using 1/4" 20-UNC threaded
screws (4 locations). Vibration dampeners or isolators for additional vibration reduction
may also be used (user supplied).
Thread the included mounting
screws (4) through the bracket holes and
into the ProPak6 mounting hole
Align the included mounting
brackets (2) over the
mounting holes of
the ProPak6
Flip the ProPak6
upside down
(Ø6.8)
Typical
60.0
2
Figure 1: Mounting Bracket Installation
200.0
Thickness of Mounting plate (T)
[T + 0.25"] min - [T + 0.375"] max
6.8
18.20
Total length of screw
If mounting a ProPak6 to a fixed location without
using the provided backets, the total length of the
mounting screw must have a range of T+0.25"
minimum by T+0.375" maximum. Use 1/4"-20
screws to secure the receiver, torqued to
2 foot-pound (24 inches-pounds).
6 mounting features sized for 1/4" or M6 hardware.
Accommodates 5/8" or 16 mm diameter washer.
Use a screw driver
to securely
tighten screws (4)
Advertisement
Table of Contents
