Table of Contents
Advertisement
Wi-Fi Client
1. Connect the ProPak6 to a computer using one of the communication ports and turn power on.
Scanning
2. Log WIFICLISCANRESULTS ONCHANGED to display a list of the scan results.
3. Log WIFICLISTATUS ONCHANGED to monitor the connection status.
4. Issue the following commands:
WIFICONFIG MODE CLIENT
WIFICONFIG STATE ENABLED
WIFICLICONTROL SCAN
5. Review the WIFICLISCANRESULTS log for any detected APs.
Connecting
6. Issue WIFICLICONFIG 1 SSID XXXX, where XXXX is the open AP to connect to.
7. Issue the following commands:
WIFICLICONFIG 1 ENABLED TRUE
WIFICLICONTROL APPLYCONFIG
Refer to the WIFICLICONFIG command in the
Reference
personal and WPA2 personal as well as additional log and command details.
Once Wi-Fi is connected, the ProPak6 Client is accessible on the LAN.
8. If Internet access is required over this interface, issue the SETPREFERREDNETIF WIFI command.
9. Issue the SAVECONFIG command to save the configuration to Non-Volatile Memory (NVM).
Manual-OM20000129 for instructions on connecting to WPA
defines receivers as Client
enables Client receiver
initiates scanning for AP
OEM6 Family Firmware
11
Advertisement
Table of Contents
