Draytek Vigor2830 Series User Manual page 97

ISP Access Setup
MTU
PPP Setup
IP Address Assignment
Method(IPCP)
client to establish a tunnel to a DSL modem on the WAN
interface.
Enable L2TP - Click this radio button to enable a L2TP
client to establish a tunnel to a DSL modem on the WAN
interface.
Disable – Click this radio button to close the connection
through PPTP or L2TP.
Server Address - Specify the IP address of the PPTP/L2TP
server if you enable PPTP/L2TP client mode.
Specify Gateway IP Address – Specify the gateway IP
address for DHCP server.
Username -Type in the username provided by ISP in this
field.
Password -Type in the password provided by ISP in this
field.
Index (1-15) in Schedule Setup - You can type in four sets
of time schedule for your request. All the schedules can be
set previously in Application >> Schedule web page and
you can use the number that you have set in that web page.
It means Max Transmit Unit for packet. The default setting
is 1442.
PPP Authentication - Select PAP only or PAP or CHAP
for PPP.
Idle Timeout - Set the timeout for breaking down the
Internet after passing through the time without any action.
WAN IP Alias - If you have multiple public IP addresses
and would like to utilize them on the WAN interface, please
use WAN IP Alias. You can set up to 8 public IP addresses
other than the current one you are using.
Fixed IP - Usually ISP dynamically assigns IP address to
you each time you connect to it and request. In some case,
85
Vigor2830 Series User's Guide