Draytek Vigor2830 Series User Manual page 262

Item
Subnet
IKE Authentication
Method
Vigor2830 Series User's Guide
Description
SSL Tunnel – Allow the remote dial-in user to make an SSL
VPN connection through Internet.
Specify Remote Node - Check the checkbox to specify the IP
address of the remote dial-in user, or peer ID (used in IKE
aggressive mode). If you uncheck the checkbox, the
connection type you select above will apply the authentication
methods and security methods in the general settings.
Netbios Naming Packet

Pass – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.

Block – When there is conflict occurred between the
hosts on both sides of VPN Tunnel in connecting, such
function can block data transmission of Netbios Naming
Packet inside the tunnel.
Multicast via VPN - Some programs might send multicast
packets via VPN connection.

Pass – Click this button to let multicast packets pass
through the router.

Block – This is default setting. Click this button to let
multicast packets be blocked by the router.
Chose one of the subnet selections for such VPN profile.
Assign Static IP Address – Please type a static IP address for
the subnet you specified.
User Name - This field is applicable when you select PPTP or
L2TP with or without IPSec policy above. The maximum
length for username is 16 characters.
Password - This field is applicable when you select PPTP or
L2TP with or without IPSec policy above. The maximum
length for password is 16 characters.
Enable Mobile One-Time Passwords (mOTP) - Check this
box to make the authentication with mOTP function.
PIN Code – Type the code for authentication (e.g, 1234).
Secret – Use the 32 digit-secret number generated by mOTP in
the mobile phone (e.g., e759bb6f0e94c7ab4fe6).
This group of fields is applicable for IPSec Tunnels and L2TP
with IPSec Policy when you specify the IP address of the
remote node. The only exception is Digital Signature (X.509)
can be set when you select IPSec tunnel either with or without
specify the IP address of the remote node.
Pre-Shared Key - Check the box of Pre-Shared Key to invoke
this function and type in the required characters (1-63) as the
250