Draytek Vigor2830 Series User Manual page 121

D e t a i l s P a g e f o r L
D e t a i l s P a g e f o r L
There are two configuration pages for LAN1, Ethernet TCP/IP and DHCP Setup (based on
IPv4) and IPv6 Setup. Click the tab for each type and refer to the following explanations for
detailed information. Below shows the settings page for IPv6.
It provides 2 daemons for LAN side IPv6 address configuration. One is RADVD(stateless)
and the other is DHCPv6 Server (Stateful).
Available settings are explained as follows:
Item
RADVD Configuration
A N 1 – I P v 6 S e t u p
A N 1 – I P v 6 S e t u p
Description
Enable – Click it to enable RADVD server. The router
advertisement daemon (radvd) sends Router Advertisement
messages, specified by RFC 2461, to a local Ethernet LAN
periodically and when requested by a node sending a Router
Solicitation message. These messages are required for IPv6
stateless auto-configuration.
Disable – Click it to disable RADVD server.
Advertisement Lifetime - The lifetime associated with the
default router in units of seconds. It's used to control the
lifetime of the prefix. The maximum value corresponds to
18.2 hours. A lifetime of 0 indicates that the router is not a
default router and should not appear on the default router
109
Vigor2830 Series User's Guide