Detaching And Refitting The Press Roller - Kyocera KM-1650 Service Manual

(2) Detaching and refitting the press roller

Follow the procedure below to replace the press roller.
Procedure
1. Remove the fixing unit (see page 1-6-43).
2. Remove the two screws and then separate
the fixing right unit and left unit.
3. Remove the three screws holding the press
roller guide from fixing right unit.
4. Remove the press roller from the fixing right
unit.
5. Replace the press roller and refit all the
removed parts.
Fixing left unit
Figure 1-6-80
Press roller guide
Fixing right unit
Figure 1-6-81
Fixing right unit
Press roller
Figure 1-6-82
2DA/2DB-1
Fixing right unit
1-6-45