Kyocera KM-1650 Service Manual page 119

2DA/2DB
Maintenance
item No.
Checking the accounting counts
U920
Description
Checks the accounting counts.
Purpose
To check the accounting counts.
Method
Press the start key. The current counts of copy counter, printer counter and fax counter are displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Checking/clearing the system error counts
U925
Description
Displays and clears the count value of system error.
Purpose
To check the system error status by types. Also to clear the service call code counts after replacing consum-
able parts.
Method
Press the start key. The count for system error detection by type is displayed.
Clearing
1. Change the screen using the left/right cursor keys.
2. Select the counts for system error and select the ALL. System error counts cannot be cleared individu-
ally.
3. Press the start key. The counts are cleared.
Completion
To exit this maintenance item without changing the count, press the stop/clear key. The screen for selecting a
maintenance No. item is displayed.
Rewriting FAX program
U926
Description
Downloads the fax program and fax fonts when installing an optional fax kit.
Purpose
To run when upgrading the fax program and fax fonts.
Setting
1. Turn the power switch off and disconnect the power plug.
2. Remove the rear cover.
3. Insert Compact Flash in a notch hole of the machine.
4. While pressing the Copier key, turn on the power switch and connect the power plug. Press and hold on
the Copier key until the message "Please wait." disappears.
5. Enter the maintenance item.
6. Press the start key. Downloading of the fax program starts and the result shown below is displayed.
If the operation was successful: EXECUTE 0100
CHECKSUM ****
CODE 0000
If the operation failed: EXECUTE 0100
CHECKSUM ****
CODE XXXX
Where XXX is the error code indicating the reason for the failure.
7. Then, downloading of the fax fonts starts and the result shown below is displayed.
1-4-50
Description