Installing The Scan System (Option) - Kyocera KM-1650 Service Manual

1-3-11 Installing the scan system (option)

<Procedure>
Remove the covers.
1. Remove the six screws (a), lift the shield
cover and then remove the cover.
If the fax system is installed, remove the six
screws (a) and screw (b), lift the shield cover
and then remove the cover.
2. Remove the two screws, and take off the
cover.
Install the scanner board.
3. Insert the scanner board into the OPT1
opening of the shield box and firmly push
the CN5 connector on the scanner board all
the way into the YC12 connector on the
engine circuit board.
4. Fasten the scanner board onto the shield
box cover using the two screws that have
been removed by Procedure 2.
Cover
Screws
Figure 1-3-86
Connector
OPT1 opening
Scanner board
CN5
Figure 1-3-87
Screws
Figure 1-3-88
2DA/2DB
Shield cover
Screws (a)
Screw (b)
Screws (a)
Connector
YC12
Scanner board
1-3-43