Detaching And Refitting The Bypass Paper Feed Pulley And Bypass Separation Pad - Kyocera KM-1650 Service Manual

(7) Detaching and refitting the bypass paper feed pulley and bypass separation pad

Follow the procedure below to replace the bypass paper feed pulley and bypass separation pad.
Procedure
1. Open the front cover and remove the waste
toner box. Pull out the drawer.
2. Remove the screw and then the front left
lower cover.
3. Remove the paper conveying unit (see page
1-6-11).
4. Remove the stop ring and bushing at the
machine front side.
5. Remove the rear cover.
6. Remove the stop ring and bypass paper
feed clutch gear at the machine rear side.
Figure 1-6-22
Bushing
Figure 1-6-23
Bypass paper feed clutch gear
Figure 1-6-24
2DA/2DB
Front left lower
cover
Stop ring
Stop ring
1-6-13