Kyocera KM-1650 Service Manual page 98

Maintenance
item No.
Checking/clearing the drum count
U110
Description
Displays the drum counts for checking, clearing the figure.
Purpose
To check the drum status. Also used to clear the count after replacing the durm during regular maintenance.
Since the count was cleared before shipping, do not clear it when installing. A drum count value less than
150K, however, cannot be cleared.
Method
1. Press the start key. The drum counter count is displayed.
2. Select the CLEAR using the up/down cursor keys. If the counter value is 150K or less, CLEAR is not dis-
played.
3. Press the start key. The count is cleared, and the screen for selecting a maintenance item No. is dis-
played.
Completion
To exit the maintenance mode without changing the count, press the stop/clear key. The screen for selecting a
maintenance item No. is displayed.
Initial setting for the developer
U130
Description
Replenishes toner to the developer unit to a certain level from the toner container that has been installed.
Purpose
To operate when installing the machine.
Method
1. Press the start key. The screen for executing is displayed.
2. Select the EXECUTE using the up/down cursor keys.
3. Press the start key. Installation of toner starts and time (minutes) is indicated until the installation ends.
4. When the installation is complete, FINISHED will be displayed if the installation is successful or NG will
be displayed if it has failed. If NG is displayed, check to see if the toner container contains toner and to
see if the toner container sensor malfunctions and then try again.
Completion
Press the stop/clear key after operation is complete. The screen for selecting a maintenance item No. is dis-
played.
Setting toner loading operation
U144
Description
Sets toner loading operation after completion of copying.
Purpose
To set whether or not toner is loaded on the drum after low density copying. Normally no change is necessary
from the initial setting.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select either ON or OFF using the up/down cursor keys. The selected item is displayed in reverse.
Display
ON
OFF
Initial setting: OFF
2. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Description
Description
Toner loaded
Toner not loaded
2DA/2DB-1
1-4-29