Replacing The Power Supply Assembly - Sony HXC-100 Service Manual

2-6. Replacing the Power Supply
Assembly
1. Remove the inside panel.
(Refer to Section 1-4.)
2. Remove the SY-363 board.
(Refer to Section 2-8-18.)
3. Disconnect the harness from the connector
CN100 on the PS-755 board.
4. Remove the three screws and draw the power
supply assembly in the arrow direction.
5. Disconnect the harnesses from the connectors
CN301, CN305, and CN304 on the PS-755
board.
6. Install a new power supply assembly by
reversing the steps above.
HXC-100/V1 (E)
CN304
CN702
PS-755 board
CN301
CN305
CN100
PSW3 x 6
PSW3 x 6
Power supply
assembly
2-11