Board; Sy-363 Board - Sony HXC-100 Service Manual

2-8-18. SY-363 Board

1. Remove the inside panel.
(Refer to Section 1-4.)
2. Disconnect the fl exible card wires from the
connectors CN5 and CN7 on the SY-363

board.

n
Be careful not to bend the fl exible card wire.
This shortens the wire life.
3. Disconnect the harnesses from the connectors
CN2, CN3, CN4, CN6, and CN8 on the
SY-363 board.
4. Remove the fi ve screws to remove the SY-363
board.
5. Install a new SY-363 board by reversing the
steps above.
2-8-19. TX-126 Board
1. Open the outside panel.
(Refer to Section 1-4.)
2. Remove the four screws to detach the shield
case.
3. Disconnect the fl exible card wires from the
connectors CN1 and CN2 on the TX-126
board.
4. Disconnect the harness from the connector
CN3 on the TX-126 board.
HXC-100/V1 (E)
CN3
CN2
SY-363 board
PSW3 x 6
Shield case
CN3
TX-126 board
CN2
CN5
CN4
CN7
CN8
PSW3 x 6
PSW3 x 6
CN1
CN6
2-23