Performing Automatic Rpn Detection Effectively - Sony HXC-100 Service Manual

(6) A message "COMPLETE!" appears and the data is recorded.
n
When two RPNs are vertically adjacent to each other, record the data at the position where one
RPN can be compensated.
Then shift the cursor vertically by 1 at the same horizontal address and check whether the other
RPN can be compensated.
When the other RPN has been successfully compensated, record the data of the RPN.
When two RPNs are horizontally adjacent to each other, move the cursor to the position where
the left RPN can be compensated. Next, set RPN WIDTH to 2 and record the data, and then
check whether these RPNs can be successfully compensated.
If the RPN compensation failed, delete the data. Increase RPN WIDTH to 3, 4, ..., and select a
value that allows the best compensation.
For an RPN that has a horizontal extent (smear), increase RPN WIDTH from 1 to 2, 3, 4, ..., and
select a value that allows the best compensation.

3-6-4. Performing Automatic RPN Detection Effectively

1. Open the RPN MANAGE[S05] page of the SERVICE menu.
2. Only perform the APR of RPNs.
RPNs of three channels are automatically detected at the same time through this operation.
ITEM: AUTO CONCEAL → EXEC
m
. Set IRIS at the CLOSE position.
. Set the BARS switch to OFF.
. Set the SHUTTER switch to OFF.
. If AUTO CONCEAL is executed with a wrong switch setting, delete all the recorded data. Make
these settings and execute AUTO CONCEAL carefully so that the RPN compensated data is not
deleted completely.
ITEM: RPN ALL PRESET → EXEC
3-30
HXC-100/V1 (E)