Printer Parameters - Custom Audio Electronics VKP80II User Manual

5.4 Printer parameters

This printer allows the confi guration of the parameters listed in the following table.
The parameters marked with the symbol
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
RS232 BAUD RATE
RS232 DATA LENGTH
RS232 PARITY
RS232 HANDSHAKING
BUSY CONDITION
USB ADDRESS NUMBER Numerical address code for the univocal identifi cation of the USB device (in case of
USB STATUS MONITOR
AUTOFEED
D are the default values.
Communication speed of the serial interface:
115200 19200 D
57600 9600
38400 4800
Number of bit used for characters encoding:
7 bits/car
D
8 bits/car
Bit for the parity control of the serial interface:
None D = parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
Handshaking:
XON/XOFF = software handshaking
D
Hardware = hardware handshaking (CTS/RTS)
Activation mode for Busy signal:
D
RXFull = Busy signal is activated when the buffer is full
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status
and the buffer is full
NOTE: Parameter valid only with serial interface; using this parameter, it is possible to select whether
the Busy signal is activated when the printer is both in Off Line status and the buffer is full or only if the
reception buffer is full.
more than a USB device connected with the same PC):
0 D 3 6
1 4 7
2 5 8
NOTE: This parameter is used to identify univocally the USB printer by a numerical address code, if on
the PC are connected two printers that are the same models.
Setting for the driver module Status Monitor:
Disabled D = Status Monitor disabled
Enabled = Status Monitor enabled
NOTE: The Status Monitor is an additional printing driver component that allows the printer status moni-
toring. It must be enabled only if the Status Monitor specifi c driver was installed.
Setting of the Carriage Return character:
CR disabled D = Carriage Return disabled
CR enabled = Carriage Return enabled
2400
1200
9
5. CONFIGURATION
VKP80II 31
User Manual