Kyocera ECOSYS M6026cdn Type B Operation Manual page 494

Error Message
Error Code:2101,
2102, 2103, 2201, 2202,
2203, 2231, 3101
Error Code:4701,
5101, 5102, 5103, 5104,
7102, 720f
Error Code:9181
Error Code:1101
Error Code:1102
Error Code:1104
Error Code:1105
Error Code:2101,
2102, 2103, 2201, 2202,
2203
Error Code:2204
Checkpoints
Did you enter an invalid host
name or IP address?
Is the wrong port number
specified?
Are you correctly connected
to the network?
–
Have more than 999 original
pages been scanned?
Scan To Email Error Code
Is the SMTP/POP3 server
name incorrect?
Did you specify an invalid
user or password?
Did you specify the
destination address?
Is SMTP protocol enabled?
Is "Other Authenticate"
selected when POP before
SMTP authentication is
performed?
Is the specified server an
SMTP server?
Are you correctly connected
to the network?
Were you attempting to
send too much data?
Corrective Actions
Enter the correct host name or IP
address.
Specify the correct port number.
Make sure that the network cable has
been correctly connected.
Make sure that the network
environment (server, hub, or other
LAN network) is operating correctly.
Turn the main power switch off and
then on. If this occurs repeatedly,
write down the error code that
appears in the message display and
contact a service technician. (See the
procedure in
Machine failure. Call
)
service.
If there are more than 999 original
pages, send the pages in separate
batches.
Set the correct server name in
Command Center RX.
Enter the correct user name and
password.
Specify the destination address.
Enable SMTP protocol in Command
Center RX.
Select a valid POP3 user other than
"Other".
Set the correct server name in
Command Center RX.
Make sure that the network cable has
been correctly connected.
Make sure that the network
environment (server, hub, or other
LAN network) is operating correctly.
Change the size that can be sent in
Command Center RX.
10-14
Troubleshooting
Reference
Page
—
—
—
—
—
—
—
—
—
—
—
—
—